Epson SureColor SC-S70600 User Manual page 8

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
E
Tensioner
The tensioner maintains tension to prevent the media sagging as it is taken up.
F
Roll core holder locking screw
The locking screws keep the roll core holders in place once they have been attached to the roll core. There are two lift
levers: one on the left and one on the right.
G
Roll support
Place the used roll core for media take-up on these holders. There are two supports: one on the left and one on the
right.
H
Auto switch
Use this switch to select the auto take-up direction. Choose Off to disable auto take-up.
I
Manual switch
Use this switch to select the manual take-up direction.AutoThe selected option takes effect when the Auto switch is
in the Off position.
J
Casters
There are two casters on each leg. Once installation is complete, the front casters should be kept locked while the
printer is in use.
K
Airflow vents
These vents vent air from inside the printer. Do not obstruct these vents.
L
Waste ink bottle holder
Place the waste ink bottle in this holder.
M
Adjuster
The adjusters keep the printer in place. After installing the printer, keep it securely in place during use.
N
Waste ink bottle
Waste ink collects in this bottle.
Replace with a new waste ink bottle when the level approaches the line.
O
Waste ink tube
Waste ink is discharged from this tube. Be sure the end of this tube is in the waste ink bottle while the printer is in
use.
P
Ink cartridge/replacement cartridge
The number of each type of cartridge installed varies with the option selected for color mode.
SC-S70600 series: 8 colors/10 colors
SC-S50600 series: 4 colors/5 colors
In 8 or 4 color mode, use replacement cartridges as well to fill all slots.
Q
Lock levers
Raise the levers to unlock the ink cartridges prior to removal. Lower the levers to lock the cartridges in place after
insertion.
R
Cartridge check lamp
This lamp lights when an ink cartridge error occurs.
Introduction
8