Epson SureColor SC-S70600 User Manual page 64

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Note:
❏ Head Alignment varies with the media used. Load
the media that will be used in the actual print job.
Head alignment is not available under the following
conditions:
❏
The media is transparent or colored.
❏
The printer is exposed to direct sunlight or
interference from other ambient light sources.
Shade the printer from sources of interference.
❏
2.5 is selected for Platen Gap in the setup menu.
Choose another option for Platen Gap.
❏ Head Alignment may also fail to produce the
expected results if the nozzles are clogged. Perform
head cleaning to remove any clogs.
❏ Auto Head Alignment may not be available when
2.0 is selected for Platen Gap in the setup menu. If
auto gap adjustment is not available, perform gap
adjustment manually.
A
Use the d/u buttons to select Head Alignment
and press the Z button.
B
Use the d/u buttons to select Auto(Bi-D) and
press the Z button.
C
Press the Z button to print a test pattern and
perform auto head alignment.
Heating & Drying
Set the temperature of the heaters or turn the fan for the
additional print drying system (supplied with the
SC-S50600 series; optional with other models) on or off.
Note:
Adjust heater temperature as follows:
❏ Set the heaters to the temperatures recommended in
the documentation provided with the media, if
available.
❏ Raise the temperature if the print results are blurred
or smudged or the ink clots. Note, however, that
raising the temperature too high can cause the
media to shrink, wrinkle, or deteriorate.
This section details the steps involved in setting the
temperature for the heaters.
A
Use the d/u buttons to select Heating & Drying
and press the Z button.
Basic Operations
B
Select Heater Temperature and press the Z
button.
C
The temperatures for the pre-, platen, and after
heaters can each be adjusted separately.
Use the r/l buttons to select a heater. From left,
the options are pre-heater, platen heater, and
after heater.
After selecting the desired heater, use the d/u
buttons to choose the temperature.
D
Select the desired option and press the Z
button.
E
Press the y button twice to return to the
customize settings menu.
Media Suction
While printing, the printer uses suction to maintain the
correct distance between the media and the printer
head; the amount varies with the type of media. Less
suction is used for thin media that would not print or
feed correctly at high levels of suction.
A
Use the d/u buttons to select Media Suction and
press the Z button.
B
Use the d/u buttons to choose a value.
C
Select the desired option and press the Z
button.
D
Press the y button to return to the customize
settings menu.
Head Movement
Choose the range in which the print head moves during
printing.
A
Use the d/u buttons to select Head Movement
and press the Z button.
B
Use the d/u buttons to select the desired setting
and press the Z button.
For faster printing, select Data Width.
64