Epson SureColor SC-S70600 User Manual page 101

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
RIP Settings
Item
Platen Gap
Head Alignment
Input thickness.
Auto(Uni-D)
Auto(Bi-D)
1
Auto(Dual Head)
Manual(Uni-D)
Manual(Bi-D)
Manual(Dual Head)
Roll Type
Tension Measurement
Media Tension
1 to 30 (media setting bank number)
Item Parameter
Setting Name
Using the Control Panel Menu
Parameter Explanation
1.5 Change Platen Gap (the gap between the print head and the media) for
the media setting bank selected in the software RIP.
2.0
The default setting of 1.5 is recommended in most situations. Choose 2.0 if
printout is scratched or smudged. Select 2.5 only if print results are still
2.5
smudged when 2.0 is selected. Choosing a larger gap than required may
result in ink stains inside the printer, reduced print quality, or shorter
product life.
0.1 to 1.0 mm (4 Enter a value for media thickness of from 0.1 to 1.0 mm (4 to 60 mil).
to 40 mil)
Print Select Head Alignment to realign the print head when print results seem
grainy or out of focus. Auto adjustment aligns the head automatically
using data collected by a sensor while a test pattern is printed. U
Alignment" on page 63
In manual adjustment, you need to check the pattern and enter the
optimum adjustment value for alignment. U
Misalignment (Head Alignment)" on page 66
1
Printable Side Choose Printable Side Out or Printable Side In according to how the
Out media is rolled.
Printable Side
In
Periodically
Choose Periodically or Every Page to have the printer automatically
monitor and adjust media tension during printing for optimal results, Off
Every Page
to disable automatic tension adjustment.
Periodically is recommended in most circumstances.
Off
The printer may however be unable to adjust tension appropriately for
some media, resulting in excessive slack or other maladjustments that
cause printing problems, in which case you should select Off. Note,
however, that Off may result in unusually large margin between pages. In
addition, printing may not stop and the inside of the printer may become
stained. Observe the following precautions:
❏
❏
Select Every Page for more precise tensioning, but note that print times
will increase.
0 to 40 Increase tension if creases appear in the media during printing. The higher
the value, the greater the tension.
Explanation
Assign the media setting bank a name up to 22 half-size characters long.
Using distinctive names makes it easier to select banks for use.
Do not print at the end of a roll
Do not select Off for Media End Check.
101
"Head
"Correcting Print