Epson SureColor SC-S70600 User Manual page 102

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Item Parameter
Feed Adjustment Auto
Manual
Platen Gap 1.5
2.0
2.5
Head Alignment Auto(Uni-D)
Auto(Bi-D)
Auto(Dual Head)
Manual(Uni-D)
Manual(Bi-D)
Manual(Dual Head)
Heating & Drying
Heater Pre-heater/platen
Temperature heater: 30 ˚C to 50 ˚C
(86 ˚F to 122 ˚F)
After heater: 30 ˚C to
55 ˚C (86 ˚F to 131 ˚F)
Drying Time Per 0 to 10sec
Pass
Using the Control Panel Menu
Explanation
Use this option if banding (horizontal banding, lines, or strips of uneven
color) persists after head cleaning and head alignment have been
performed.
Auto feed adjustment adjusts the feed automatically using data collected
by a sensor while a test pattern is printed. U
page 62
In manual feed adjustment, the user visually inspects print results and
enters the adjustment value by hand. U
Adjustment)" on page 67
Choose the platen gap (the distance between the print head and the
media).
The default setting of 1.5 is recommended in most situations. Choose 2.0 if
printout is scratched or smudged. Select 2.5 only if print results are still
smudged when 2.0 is selected. Choosing a larger gap than required may
result in ink stains inside the printer, reduced print quality, or shorter
product life.
Select Head Alignment to realign the print head when print results seem
grainy or out of focus. Auto adjustment aligns the head automatically
using data collected by a sensor while a test pattern is printed. U
Alignment" on page 63
1
In manual adjustment, you need to check the pattern and enter the
optimum adjustment value for alignment. U
Misalignment (Head Alignment)" on page 66
1
The temperatures for the pre-, platen, and after heaters can each be
adjusted separately.
Select the time the print head pauses to allow drying after each pass.
Choose from values between 0.0 and 10.0 seconds. The time needed for
the ink to dry varies with ink density and the media used. If the ink blurs on
the media, set a longer time for drying the ink.
Increasing the drying time increases the time needed to print.
102
"Feed Adjustment" on
"Feed Adjustment (Manual Feed
"Head
"Correcting Print