Epson SureColor SC-S70600 User Manual page 41

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
N
Hold the center of the media and raise the media
loading lever.
O
Pull the media straight forward until the edge has
past the label on the left side of the after heater.
Keep the right edge of the media parallel with the
scale markings on the two labels on the right side
of the after heater.
c
Important:
Perform Steps 14 to 3 in reverse order and
repeat the loading process if the right edge of
the media is not within the scale markings. Do
not attempt to reposition the roll holders
while they are inserted in the media.
P
Adjust the position of the pressure rollers.
The low pressure rollers are used for normal
printing, the high pressure rollers for ink
layering. Their positions vary with the width of
the media and the rollers used.
Basic Operations
Position the low pressure rollers 5 mm and the
high pressure rollers 10 mm from the edges of the
media, keeping them in the bounds shown by the
black labels (see "Printable Area").
"Printable area" on page 70
U
Ink layering U
page 23
Q
Move unused rollers and rollers that can not be
positioned over the media to the sides of the black
labels.
R
Lower the media loading lever to hold the media
in place.
To print immediately, proceed to Step 19.
For information on loading the media into the
auto take-up reel unit, see:
41
"High Print Quality" on