Epson SureColor SC-S70600 User Manual page 105

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Item
2
Head Strike Warning
Warning Options
Warning Level Options
Auto Nozzle Check
Nozzle Check Cycle
Options When
Clogged
Print Nozzle Pattern
Using the Control Panel Menu
Parameter Explanation
Off Choose whether the printer automatically detects (On) or does not
automatically detect (Off), the media lifting during printing.
On
If On is selected, the printer will stop when the media lifts to prevent a head
strike.
On is recommended if you will be performing other tasks and are unable to
give the printer your full attention during printing.
The printer may fail to detect the media lifting in the following instances
even when On is selected.
❏
Off is selected for Media Size Check
❏
The Platen Gap is set to 2.5
❏
Transparent film media is used
❏
The media has a high gloss
1 to 5 The higher the value, the more sensitive the printer to media lift.
Choose lower values to reduce the number of stoppages.
Off Choose the frequency with which the printer performs an Auto Nozzle
Check: never (Off) or once every 1 to 10 pages. Auto nozzle checks will not
1 to 10 pages
be performed while Off is selected.1If 1 to 10 is selected, the printer will
automatically checks for clogs at the specified interval by scanning a test
pattern with a sensor as it is being printed.
Note that Auto Nozzle Check is not capable of detected all types of clog.
In addition, Auto Nozzle Check is not available under the following
conditions:
❏
The media is transparent or colored.
❏
The printer is exposed to direct sunlight or interference from other
ambient light sources.
Shade the printer from sources of interference.
❏
2.5 is selected for Platen Gap in the setup menu.
Choose another option for Platen Gap.
Continue Printing Choose how the printer responds when an auto nozzle check detects
clogged nozzles.
Stop Printing
If Continue Printing is selected, the printer will display Nozzle Clog
Detected but keep printing. Stop printing and perform head cleaning if
you judge it necessary on inspecting the print results.
If Stop Printing is selected, the printer will display Nozzle Clog Detected
and pause printing. Inspect the print results and choose whether to
resume or suspend printing according to the extent of the clog.
Off Choose the frequency with which the printer prints a nozzle test pattern:
never (Off) or once every 1 to 10 pages. Periodic test patterns will not be
1 to 10 pages
printed while Off is selected.1To print a test pattern at the top of every 1 to
10 pages, select an option between 1 and 10. When printing is complete,
you can visually inspect the pattern to determine whether there may be
faint or missing colors in the preceding or following printout.
105