Epson Stylus Pro WT7900 User Manual page 28

Epson Stylus Pro WT7900/7910
CUSTOM PAPER SETUP
When you use non-Epson media, you need to make settings suitable for the media.
After you have selected the paper number, make the following settings. Make sure to select the paper from PAPER
TYPE first, and then make the PLATEN GAP setting and so on.
To set the custom paper, see the following section.
See "Printing with Non-Epson Media" on page 60
Item
PAPER TYPE
PLATEN GAP
THICKNESS PATTERN
PAPER FEED ADJUST
DRYING TIME
PAPER SUCTION
SET ROLL PAPER TENSION
REMOVE SKEW
User's Guide
The Control Panel
Parameter
ClearProof Film
Premium Glossy 250
Premium Glossy Sheet
Proofing Paper W Sm
NO PAPER SELECTED
NARROW
STANDARD
WIDE
WIDER
WIDEST
PRINT
-0.70% to +0.70%
0.0sec to 10.0sec
STANDARD
-1 to -4
NORMAL
HIGH
EXTRA HIGH
ON
OFF
Explanation
You can select the media type that is most similar to the paper
you are using.
You can adjust the distance between the print head and the
paper.
STANDARD: Normally, select STANDARD.
NARROW: Use this when printing on thin paper.
WIDE or WIDER: Select this if you find that printed images are
smeared.
WIDEST: Select this if printed images are still smeared after
trying WIDE or WIDER.
You can print the paper thickness detection pattern and select
the appropriate number from the printed pattern.
You can set the paper feed amount of the printable area. The
range is -0.70 to 0.70%. If the paper feed value is too large, white
horizontal micro-banding may appear. If the paper feed value is
too small, dark horizontal micro-banding may appear.
You can set the ink drying time for each print head pass. The
range is 0 to 10 seconds. Depending on the ink density or paper
type, the ink may not dry quickly. In this case, set a longer drying
time.
You can set the suction pressure used to feed the printed paper.
When using a cloth or thin paper or when wrinkles appear in the
paper during printing, select HIGH or EXTRA HIGH.
You can select whether or not to perform this operation to
reduce paper skew.
28