Head Alignment; Network Setup - Epson Stylus Pro WT7900 User Manual

Epson Stylus Pro WT7900/7910

HEAD ALIGNMENT

You can perform print head alignment. For more details, see the following section.
See "Print head alignment" on page 80
Item
PAPER THICKNESS
ALIGNMENT

NETWORK SETUP

When you use the printer on the network, set the following items.
* Default settings
Item
NETWORK SETUP
IP ADDRESS SETTING
IP,SM,DG SETTING
BONJOUR
INIT NETWORK SETTING
OPTIONS SETUP
When you use the optional equipment, set the following items.
Item
SpectroProofer
User's Guide
The Control Panel
Parameter
SELECT PAPER TYPE
SELECT THICKNESS
AUTO
MANUAL
Parameter
DISABLE *
ENABLE
AUTO *
PANEL
Ask your system administrator for detailed information.
ON *
OFF
EXECUTE
Parameter
STATUS INFORMATION
DEVICE ALIGNMENT
Explanation
When using Epson special media, select the paper type. If you
use non-Epson special media, enter the paper thickness in the
range of 0.1 to 1.5 mm.
When you select AUTO, the adjustment pattern for output is read
by the sensor and the optimum adjustment value is registered
automatically in the printer. When you select MANUAL, you need
to check the pattern and enter the value for alignment.
Explanation
You can make the network settings using the printer's control
panel. The following items appear only when ENABLE is
selected. After setting the items, press the
NETWORK SETUP menu, so the network is reset and the network
connection is available after 40 seconds. The NETWORK SETUP
menu does not appear while resetting the network.
You can select the method for setting an IP address to the
printer. When you select PANEL, IP,SM,DG SETTING is displayed.
You can enable or disable the Bonjour setting.
You can return the network settings of the printer to the factory
default value.
Explanation
Displays the settings of the attached SpectroProofer (DEVICE
VERSION: ILS20EP, CALIBRATION TILE S/N, DEVICE
TEMPERATURE, FIRMWARE VERSION, AIR TEMPERATURE,
BACKING COLOR, ILS Calibration Status).
You can execute setting up for the attached SpectroProofer.
30
button in the