Accessing The Postscript Printer Driver; Using Appletalk Under Windows 2000; Using The Postscript Printer Driver With Macintosh; Installing The Postscript Printer Driver - Epson AcuLaser M4000N User Manual

9. Click Have Disk in the Add Printer Wizard and specify the following path for the CD-ROM. If
your CD-ROM drive is D:, the path will be D:\ADOBEPS\ENGLISH\WIN2K_XP\PS_SETUP.
Then click OK.
Note:
Change the drive letter as needed for your system.
10. Select the printer and click Next.
11. Follow the on-screen instructions for the rest of the installation.
12. When installation is done, click Finish.

Accessing the PostScript printer driver

You can change the PostScript printer driver settings in the PostScript printer driver. To access the
printer driver, see "Accessing the printer driver" on page 172.

Using AppleTalk under Windows 2000

Use the following settings if your machine is running Windows 2000, and the printer is connected
through an network interface using the AppleTalk protocol:
❏ Select PS3 as the Network setting in the control panel's Emulation Menu.
❏ On the Device Settings sheet of the printer's Properties dialog box, make sure that SEND
CTRL-D Before Each Job and SEND CTRL-D After Each Job are set to No.
❏ TBCP (Tagged binary communications protocol) cannot be used as the Output Protocol setting.

Using the PostScript Printer Driver with Macintosh

Installing the PostScript printer driver

Note:
Make sure that no applications are running on your Macintosh before installing the printer driver.
AcuLaser M4000 Series
About the PostScript Printer Driver
User's Guide
189