Epson AcuLaser M4000N User Manual page 82

AcuLaser M4000 Series User's Guide
Check Paper Type
The paper loaded in the printer does not match the paper type setting in the printer driver. Paper
that matches only the paper size setting will be used for printing.
To clear this error, select Clear Warning from the control panel's Reset Menu. See "How to access
the control panel menus" on page 53 for instructions.
Collate Disabled
Printing by specifying the number of copies is no longer possible due to a lack of memory (RAM).
If this error occurs, print only one copy at a time.
To clear this error, select Clear Warning from the control panel's Reset Menu. See "How to access
the control panel menus" on page 53 for instructions.
Cooling Down
The printer is cooling down.
DM Error yyy
The Duplex Unit has become separated from the printer.
Duplex Memory Overflow
There is not enough memory for duplex printing. The printer prints only on the front and ejects the
paper. To clear this error, follow the instructions below.
If Off is selected as the Auto Cont setting on the control panel's Setup Menu, press the Start/Stop
button to print on the back of the next sheet, or press the + Cancel Job button to cancel the print
job.
If On is selected as the Auto Cont setting on the control panel's Setup Menu, printing continues
automatically after a certain period of time.
Face-down Full
The output paper at the face-down tray is full. Remove the paper that has been output and press
the Start/Stop button. Printing resumes.
Face-up Path Selected
Even though duplex printing has started or the Stacker is set as the output tray in the printer driver,
the paper path lever is set to the face-up position. Set the paper path lever to the face-down
position, or press the Start/Stop button or the + Cancel Job button.
Using the Control Panel 82