Epson AcuLaser M4000N User Manual page 105

3. Loosen the screws on both sides of the Stacker, and while holding up the Stacker, remove the
right and left tabs from the holes on the top of the printer.
Note:
If the Duplex Unit is installed, open the Duplex Unit's cover before loosening the screws.
4. Insert the right and left tabs of the top cover into the holes on the top of the printer, and then
tighten the two screws.
5. Reconnect the interface cable and power cord, and then turn on the printer.
AcuLaser M4000 Series
Installing Options
User's Guide
105