Epson AcuLaser M4000N User Manual page 76

AcuLaser M4000 Series User's Guide
Text
Sets the page length in lines. For this option, a line is assumed to be 1 pica (1/6 inch). If you change
the Orientation, Page Size, or T. Margin settings, the page length setting automatically returns to
the default for each paper size.
CG Table
Use the character generator (CG) table option to select the graphics character table or the italics
table. The graphics table contains graphic characters for printing lines, corners, shaded areas,
international characters, Greek characters, and mathematical symbols. If you select Italic, the
upper half of the character table is defined as italic characters.
Country
Use this option to select one of the thirteen international symbol sets. See the Font Guide for samples
of the characters in each country's symbol set.
Auto CR
Specifies whether the printer performs a carriage-return/line-feed (CR-LF) operation whenever
the printing position goes beyond the right margin. If you select Off, the printer does not print any
characters beyond the right margin and does not perform any line wrapping until it receives a
carriage-return character. This function is handled automatically by most applications.
Auto LF
If you select Off, the printer does not send an automatic line-feed (LF) command with each
carriage-return (CR). If On is selected, a line-feed command is sent with each carriage-return. Select
On if your text lines overlap.
Bit Image
The printer is able to emulate the graphics densities set with the printer commands. If you select
Dark, the bit image density is high, and if you select Light, the bit image density is low.
If you select BarCode, the printer converts bit images to bar codes by automatically filling in any
vertical gaps between dots. This produces unbroken vertical lines that can be read by a bar code
reader. This mode will reduce the size of the image being printed, and may also cause some
distortion when printing bit image graphics.
ZeroChar
Selects whether the printer prints a slashed or unslashed zero.
Using the Control Panel 76