Epson AcuLaser M4000N User Manual page 88

AcuLaser M4000 Series User's Guide
Replace Fuser
The fuser has reached the end of its service life and needs to be replaced.
Turn the printer off and wait for 30 minutes, then replace the fuser unit with a new one. See "Fuser
Unit" on page 126 for instructions.
Replace Maintenance Unit
The maintenance unit has reached the end of its service life and needs to be replaced. If this error
occurs, consult your dealer.
Replace Toner Cartridge
The imaging cartridge has reached the end of its service life and needs to be replaced. See "Imaging
Cartridge" on page 122 for instructions.
Reserve Job Canceled
The printer cannot store the data of your print job using the Reserve Job function. The maximum
number of print jobs stored on the printer's memory has been reached, or the memory has no more
memory available to store a new job. To store a new print job, delete a previously stored job. Also,
if you have any Confidential Jobs stored, printing those jobs will make more memory available.
You may also increase the available memory space by changing the RAM Disk setting to Normal or
Maximum. For details, see "Setup Menu" on page 61.
To clear this error, select Clear Warning from the control panel's Reset Menu. For instruction
about accessing the control panel menus, see "How to access the control panel menus" on page 53.
Reset
The printer's current interface has been reset and the buffer has been cleared. However, other
interfaces are still active and retain their settings and data.
Reset All
All printer settings have been reset to the default configuration, or to the last settings that were
saved.
Reset to Save
A control panel menu setting was changed while the printer was printing. Press the Start/Stop
button to clear this message. The setting will become effective after printing has finished.
Alternatively you can clear this message by performing Reset or Reset All on the control panel.
However, the print data will be deleted.
Using the Control Panel 88