Parts Replacement Time Has Passed; Multi-Sensor Error - Canon imagePROGRAF iPF6200 User Manual

Parts replacement time has passed.

It is past the recommended time to replace
consumables for which service is required.
Unknown le.
Invalid data format.
Calibration There is a problem with the multi-sensor.
The performance of a sensor inside the printer may
be impaired.

Multi-sensor error

Direct sunlight or strong lighting may be shining on
the printer and causing the sensor to malfunction.
The performance of a sensor inside the printer may
be impaired.
Roll feed unit err
The Roll Feed Unit is not working.
No Roll Feed Unit.
The printer has received a print job that species
rolls, but the Roll Feed Unit is not installed.
Cause
Cause
Cause
Cause
Cause
Cause
Corrective Action
Contact your Canon dealer for assistance.
Corrective Action
Check the print job and resend it.
Corrective Action
Press the OK button and cancel calibration. Contact
your Canon dealer for assistance.
Corrective Action
Take steps to ensure the printer is not used when
exposed to direct sunlight or strong lighting.
Contact your Canon dealer for assistance.
Corrective Action
Turn off the printer, remove the Roll Feed Unit
momentarily, and then reinstall it.
(→P.146)
(→P.147)
If the message is still displayed after you do this,
contact your Canon dealer for assistance.
Corrective Action
Install the Roll Feed Unit and resend the print job.
(→P.147)
Other Messages
Error Message 707