Modifying A Wash Protocol - Dynex OPSYS MW 91000051 User Manual

Modifying a Wash Protocol

Modifying a Wash Protocol
An existing wash protocol can be modified by using many of the same
commands that are used to create a wash protocol.
To modify a wash protocol:
1. Display the main menu:
2. Use the up and down scroll keys to select the wash protocol to
be modified (or enter the number using the keypad). The display
will read:
3. Select PROGRAM. If the wash protocol is password protected,
the display will read:
4. Enter the Password using the keypad and press ENTER.
5. After a password is successfully entered (or if a password was
not specified for the selected protocol), the display will read:
56
1: NAME_01
SETUP PROGRAM
4: NAME_04
SETUP PROGRAM
Enter password
Note: If a Password is not specified for the
selected wash protocol, the display will read
as shown in Step 5.
Note: If the Password is entered incorrectly an
error message is displayed. The operator is
allowed three attempts to enter the password.
After the third attempt, the main menu
(Step 1) will again be displayed.
Note: If the password for a protocol is lost, the
ability to access the method and the method
position are also lost.
Edit name
4: NAME_04 COPY
Opsys MW™ User's Guide