Table of Contents
Advertisement
Creating a New Wash Protocol
To specify a Soak (outside of a Move):
1. Scroll right to display the next selection. The display will read:
2. Select SOAK. The display will read:
3. Enter the desired soak duration (1 to 999 seconds) using the
keypad.
4. Press ENTER The display will read:
54
Note: A Soak can be performed either within
or outside of a Move cycle. The procedure
below describes the procedure for specifying a
soak outside of a Move cycle.
The procedure for specifying a Soak within a
Move cycle is described on page 47.
Select option
SOAK
END
Duration?
5
Note: A soak duration ranging from 1 to 999
seconds can be entered.
Select option
SOAK
END
Opsys MW™ User's Guide
Advertisement
Table of Contents
