Specifying The Wash Head - Dynex OPSYS MW 91000051 User Manual

Specifying the Wash Head

The HEAD command allows the installed wash head to be specified:
1. Select SETUP. The display will read:
2. Select HEAD. The current wash head selection is displayed in
the upper line:
If needed, scroll right to view the remaining selection:
3. Select the desired option using the function key. After the
selection is made, the display will again read:
Opsys MW™ User's Guide
Select option
HEAD PLATE
Wash head?
8
Wash head?
12
Select option
HEAD PLATE
Configuring the System
8
8
29