Dynex OPSYS MW 91000051 User Manual page 39

To specify parameters for a plate type:
1. Obtain an empty plate of the plate type being specified and place
it in the plate holder.
2. Select SETUP (if needed). The display will read:
Select option
3. Select PLATE. The name of the first plate is displayed in the
lower line:
Select plate
4. If needed, display a different plate number using the up or down
scroll keys (or use the keypad to enter the desired plate number).
When the desired plate number is displayed, press ENTER. The
display will read:
Enter name
5. Use the keypad to enter the plate name (up to
10 characters).
6. Press ENTER. The display will read:
DISP. HEIGHT?
Opsys MW™ User's Guide
HEAD PLATE
1: - - - - - - - - - -
Note: Dashes will be displayed if the plate has
not yet been named.
- - - - - - - - - -
Note: Refer to page 23 for instructions on
entering alphabetic characters.
180
SHOW
Note: The default value is displayed. Select
SHOW to move the wash head to the default
dispense position so that the height can be
checked. Then, determine the correct value as
outlined on page 30. Repeat the procedure as
needed.
Configuring the System
31