Dynex OPSYS MW 91000051 User Manual page 50

Creating a New Wash Protocol
To create a new wash protocol header:
1. Display the main menu.
2. Use the up or down scroll keys to display the protocol number (or
use the keypad to enter the protocol number) that is to be
created:
3. Select PROGRAM. The name of the wash protocol is displayed
in the lower line:
4. Use the keypad to enter the protocol name (up to 9 characters)
and press ENTER. The display will read:
5. Select YES if the protocol is to be password protected. The
display will read:
6. Enter the password, (up to eight numeric characters) and press
ENTER. The display will read:
42
1: - - - - - - - - - -
SETUP PROGRAM
6: - - - - - - - - - -
SETUP PROGRAM
Note: Dashes will be displayed if a protocol
has not yet been named.
Enter name
- - - - - - - - - -
Password?
YES NO
Note: Refer to page 24 for instructions on
entering alphanumeric characters.
Enter password
********
Note: If NO is selected, the Select plate
prompt (Step 7) will be displayed.
Confirm password
********
Opsys MW™ User's Guide