Pictbridge Printing - Ricoh C222DN - Aficio SP Color Laser Printer Software Manual

Direct Printing from a Digital Camera (PictBridge)

PictBridge Printing

Follow the procedure below to start PictBridge printing on this printer.
Important
❒ Memory overflow errors can occur when printing a large-pixel image using
4-up printing. To prevent memory overflow errors, add the optional memory.
❒ Do not disconnect the USB cable while data is being sent. If you do, printing
will fail.
A
Check the printer and the digital camera are both turned on.
B
Connect a USB cable between the USB host interface board installed on the
printer and digital camera.
4
The Ready indicator on the printer flashes for several seconds and then stays lit.
This indicates the printer recognizes the digital camera as a PictBridge device.
C
On your digital camera, select the images you want to print, and then spec-
ify the printing conditions.
D
The printer receives settings from the digital camera and starts printing.
Note
❒ Since printing conditions are specified on the digital camera, specifiable
parameters depend on the digital camera. For details, see the manuals pro-
vided with the digital camera.
❒ Some digital cameras require settings for manual PictBridge operation. For
details, see the manual provided with the digital camera.
❒ Some digital cameras require to turn the power switch off for a manual
PictBridge operation. For details, see the manual provided with the digital
camera.
❒ Some digital cameras need to be switched off when connecting to the print-
er. For details, see the manual provided with the digital camera.
Reference
For details about how to stop printing data, see p.31 "Canceling a Print Job".
40
ASH108S