Verify The Operating Status Of The Msa; View The Leds On The Msa; Msa1500 Startup Status Lights - HP AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard Drive Installation Manual

CAUTION:
Found" message and prompt to install an HBA driver. Cancel out of this window to prevent
the installation of an unsupported HBA driver.
Verify that each device in the SAN is operating properly.
7.

Verify the operating status of the MSA

To verify the operating status of the MSA:

• View the LEDs on the MSA

• Read the messages on the controller display panel
View the LEDs on the MSA
Each module of the MSA is equipped with LEDs. To verify that your MSA is operating properly, look
for the following LED patterns:
Table 8

MSA1500 startup status lights

LED
Power switch
Power supply module
Fan module
Fibre Channel I/O module (top LED)
SCSI I/O module (top LED)
If the above LED patterns are not illuminated:
• Check your cable connections between the device and the MSA.
• Check the availability of your power source.
• Review the setup instructions in the previous sections of this guide.
• Remove and reinsert the module.
• Refer to the HP StorageWorks 1500 Modular Smart Array maintenance and service guide,
available on the Documentation CD and the Technical documentation page of the MSA1500
website: http://www.hp.com/go/msa1500cs.
When you power on the server, the monitor may display a "New Hardware
HP StorageWorks 1500 Modular Smart Array installation guide
Condition
Amber = standby power
Solid green = power on
Solid green
Solid green
Solid green
Solid green
53