Chapter 5 Installation; Notes On Handling Drives - Fujitsu MAN3367FC - Enterprise 36.7 GB Hard Drive Product/Maintenance Manual

CHAPTER 5
This chapter describes the notes on handling drives, setting, mounting drives, confirming drive operations
after installation and preparation for use, and dismounting drives.
5.1

Notes on Handling Drives

The items listed in the specifications in Table 2.1 must be strictly observed.
(1) General notes
a) Do not give the drive shocks or vibrations exceeding the value defined in the standard because it
may cause critical damage to the drive. Especially be careful when unpacking.
b) Do not leave the drive in a dirty or contaminated environment.
c) Since static discharge may destroy the CMOS semiconductors in the drive, note the following
after unpacking:
Use an antistatic mat and body grounding when handling the drive.
Hold the DE when handling the drive. Do not touch PCAs except for setting.
Hot temperature
To prevent injury, do not handle the drive until after the device has cooled
sufficiently after turning off the power. The DE and LSI become hot during
operation and remain hot immediately after turning off the power.
C141-E133-02EN
Installation
5.1 Notes on Handling Drives
5.2 Setting
5.3 Mounting Drives
5.4 Dismounting Drives
5.5 Checking Operation after Installation and Preparing
the IDD for Use
5.6 Spare Disk Drive
CAUTION
5-1