Fujitsu MAN3367FC - Enterprise 36.7 GB Hard Drive Product/Maintenance Manual page 8

Preface
Chapter 8 Principle of Operation
This chapter explains disk drives configuration and operation of MAN series.
APPENDIX A to D
The appendixes give supplementary information, including the locations of connector, the
signal assignments of interface connectors, lists of model names and product numbers, and
fibre channel interface functions.
The model numbers have a suffix that describes the electrical requirements of the fibre
channel interface between host system and disk drive, the data formatted at the factory and
device type.
CONVENTIONS USED IN THIS MANUAL
This manual indicates;
Decimal number: Indicates as it is.
Hexadecimal number: Indicates as X'17B9', 17B9h, or 17B9H
Binary number: Indicates as "010"
DISCLAIMER
Failure of the MAN series intelligent disk drive is defined as a failure requiring
adjustments, repairs, or replacement. Fujitsu is not responsible for drive failures caused by
misuse by the user, poor environmental conditions, power trouble, host problems, cable
failures, or any failure not caused by the drive itself.
The suffix of the model name of the disk drive varies depending on the electrical
requirements, capacity, and data format at factory shipment of the fibre channel, i.e., the
interface for connecting the device type or host system and the disk drives (Note 1).
However, in this manual, the typical model names (Note 2) are used unless otherwise
noted. These disk drives may be called intelligent disk drives (IDD), drives, or devices in
this manual.
Note 1:
M AN 3 735 FC
ii
Model names
Interface types FC: Fibre Channel
Formatted capacity (100 MB units)
Disk drive size 3: 3.5 type. Hard Disk Drive
Type AN: Number of rotations 10,025min
-1
(10,025rpm)
C141-E133-02EN