Table of Contents
Advertisement
CHAPTER 8
This chapter explains the general design concepts of the disk drive. It also explains the main parts, sequences,
servo control method, and the main electrical circuits of the drive at the block level.
8.1
Outline
The principle of operation of this disk drive can be divided into two parts. The first part explains the
mechanical parts of the drive (see Section 8.2). The second part explains the servo data recorded on
a magnetic disk and explains drive control (see Sections 8.3 to 8.7).
8.2
Disk Drive Configuration
The main disk drive subassemblies are a disk enclosure (DE) and printed-circuit boards (also called
printed circuit assemblies (PCA)).
The DE contains all the moving parts of the disk drive. That is, DE contains disks, heads, spindle
mechanism, and actuator, and also air filters.
These parts are explained in Subsections 8.2.1 to 8.2.5.
Each PCA contains the electric circuit of the disk drive. See Section 8.3 for explanations of these
electric circuits.
C141-E133-02EN
Principle of Operation
8.1
Outline
8.2
Disk Drive Configuration
8.3
Circuit Configuration
8.4
Power-On Sequence
8.5
Factory-Calibration
8.6
Read/Write Circuit
8.7
Servo Control
8-1
Advertisement
Table of Contents
Troubleshooting
