Nav/Com/Transponder/Audio Panel; Adf Tuning (Optional); Dme Tuning (Optional); Enter A Transponder Code - Garmin G1000H Cockpit Reference Manual

NAV/COM/TRANSPONDER/AUDIO PANEL

ADF TUNING (OPTIONAL)

Tune the ADF using the remote ADF control head.

DME TUNING (OPTIONAL)

1) Press the DME Softkey.
2) Turn the large FMS to select the DME source field.
3) Turn the small FMS Knob to select the desired Nav radio.
4) Press the ENT Key to complete the selection.

ENTER A TRANSPONDER CODE

1) Press the XPDR Softkey to display the transponder mode selection softkeys.
2) Press the CODE Softkey to display the transponder code selection softkeys,
for digit entry.
3) Press the digit softkeys to enter the code in the code field. When entering
the code, the next key in sequence must be pressed within 10 seconds, or
the entry is cancelled and restored to the previous code. Five seconds after
the fourth digit has been entered, the transponder code becomes active.

SELECTING A COM RADIO

The COM transceiver is selected for transmitting by pressing the MIC Keys on the
Audio Panel. During reception of audio from the COM radio selected for transmission,
audio from the other COM radio is muted.
An active COM frequency displayed in green indicates that the COM transceiver is
selected on the Audio Panel (MIC1 or MIC2 Key).
Frequencies in the standby field are displayed in either white or gray. The standby
frequency in the tuning box is white. The other standby frequency is gray.
190-01254-00 Rev. A Garmin G1000H Cockpit Reference Guide for the Bell 407GX
™
Nav/Com/XPDR/Audio Panel
11