Table of Contents
Advertisement
Appendix
NOTE: After the navigation database is loaded or copied, the top SD card
may be removed.
1) With the system OFF, insert the SD card containing the new navigation database
version into the top card slot of the display (PFD or MFD) to be updated (label
of SD card facing left).
2) Turn the system ON. A prompt is displayed in the upper left corner of the
display:
3) Press the NO Softkey to proceed to loading the active database.
4) A prompt similar to the following is displayed. Press the YES Softkey to update
the active navigation database.
5) After the update completes, the display starts in normal mode.
6) Turn the system OFF and remove the SD card from the top card slot.
7) Repeat steps 1 through 6 for the other displays (PFD or MFD).
8) Apply power to the system and press the ENT Key to acknowledge the startup
screen.
9) Turn the large FMS Knob to select the AUX Page group on the MFD.
10) Turn the small FMS Knob to select the System Status Page.
11) Press the Display Database Selection Softkey to show active navigation
database information for each display (MFD1 DB, PFD1 DB). Verify the
correct active navigation database cycle information is shown for each display.
Loading the Jeppesen Navigation Database as the Standby Navigation
Database
NOTE: After the navigation database is loaded or copied, the top SD card
may be removed.
1) With the system OFF, insert the SD card containing the new navigation
database version into the top card slot of the MFD.
2) Verify that an SD card is inserted in the bottom slot of each PFD and the
MFD.
3) Turn the system ON. A prompt is displayed.
114
Garmin G1000H
Cockpit Reference Guide for the Bell 407GX
™
190-01254-00 Rev. A
Advertisement
Table of Contents
