Garmin G1000H Cockpit Reference Manual page 129

Err
Timeout
Loading Garmin Database Updates
1) With system power OFF, remove the MFD database card from the bottom
card slot of the MFD.
2) Update the Garmin databases on the MFD card.
3) Insert the MFD database card into the bottom card slot of the MFD.
4) Apply power to the system, check that the databases are initialized
and displayed on the power-up screen. When updating the terrain and
FliteCharts databases, a 'Verifying' message may be seen. If this message is
present, wait for the system to finish loading before proceeding to step 5.
5) Acknowledge the Power-up Page agreement by pressing the ENT Key or
the right most softkey.
6) Turn the large FMS Knob to select the AUX Page group on the MFD.
7) Turn the small FMS Knob to select the System Status Page.
8) Monitor the Sync Status in the Database Window. Wait for all databases to
complete synching, indicated by 'Complete' being displayed.
9) Remove and reapply power to the system.
10) Turn the large FMS Knob to select the AUX Page group on the MFD.
11) Turn the small FMS Knob to select the System Status Page.
12) Press the Display Database Selection Softkey to show database information
for each display (MFD1 DB, PFD1 DB). Verify the correct database cycle
information is shown for each database for each display.
Loading the Jeppesen Navigation Database as the Active Navigation
Database
NOTE: Loading the Jeppesen navigation database as the active database
prior to its effective date will result in the expiration date on the power-up
screen and the effective date on the AUX-System Status Page being displayed
in yellow.
190-01254-00 Rev. A
Displayed for all other errors that may cause the synchronization
process to be halted
System timed-out prior to the database transfer completing
Garmin G1000H Cockpit Reference Guide for the Bell 407GX
™
Appendix
113