Nav/Com/Transponder/Audio Panel; Enter Or Change Flight Id (If Available); Enter A Transponder Code; Dme Tuning - Garmin G1000 Reference Manual

nav/Com/transponder/audio panel

enter or Change Flight id (iF available)

1) Press the TMR/REF Softkey, then turn the large FMS Knob to highlight the
Flight ID field.
2) Turn the small FMS Knob to enter the first character.
3) Turn the large FMS Knob to select the next field.
4) Turn the small FMS Knob to enter the next desired character.
5) Repeat steps 3 and 4 until the desired Flight ID is entered.
6) Press the ENT Key to update the Flight ID.

enter a transponder Code

1) Press the XPDR Softkey to display the transponder mode selection softkeys.
2) If two transponders are available, press XPDR1 or XPDR2 to set the active
transponder. Otherwise, proceed to step 3.
3) Press the CODE Softkey to display the transponder code selection softkeys,
for digit entry.
4) Use the digit keys to enter the code in the code field. When entering the
code, the next key in sequence must be pressed within 10 seconds, or the
entry is cancelled and restored to the previous code. Five seconds after the
fourth digit has been entered, the transponder code becomes active.

dme tuning

1) Press the DME Softkey.
2) Turn the large FMS to select the DME source field.
3) Turn the small FMS Knob to select the desired Nav radio.
4) Press the ENT Key to complete the selection.

seleCting a Com radio

transmit/receive
Press the COM1 MIC, COM2 MIC, or COM3 MIC Key (optional COM, if
installed) on the audio panel.
190-00748-02 Rev. B Garmin G1000 Cockpit Reference Guide for the Cessna Caravan
nav/Com/xpdr/audio panel
9