Opening And Displaying The Camera Menu; Configuring Video Settings - Honeywell HNVE1 Reference Manual

Opening and Displaying the Camera Menu

Configuring Video Settings

Document 800-04195 Rev B
11/09
The camera menu enables you to configure the display, diagnostic, and other related
camera settings.
Note The Camera Menu is available only when IntelliBus™ or Diamond protocol is
selected in the Board Setup tab.
1. Select the PTZ Dome Setup tab, then click Open Camera Menu.
The on-screen menu for the camera options displays. Use the keyboard to select
options listed in the camera menu.
2. Press ESC to close the menu.
The video signal sent to the Web-Client from the camera has a number of settings that can
be edited which affect the video as it is displayed in the Web-Client. The Compression
Settings view enables you to configure these settings:
• Resolution
• Frame Rate
• Priority (Quality or Bite Rate)
• Picture Quality (if Quality is chosen as the priority)
• Target Bit Rate (if Bit Rate is chosen as the priority)
• Maximum Bit Rate that the camera will provide across the network
• GOP (number of frames)
1. On the Compression Settings tab, in the Statistics area, select the Received check
box to receive the bit rate and frame rates for the current image in real time.
Deselecting the check box disables the refresh rate.
Note The Received check box is disabled by default. When you log off, this check
box reverts to the disabled state.
HNVE1 V2.1 1-Channel Encoder Reference Guide
67