Ptz Camera Address Settings; Presets; Figure 5-4 Location Of Address Rotary Switches On Sample Ptz Main Board; Table 5-2 Sample Ptz Dome Address Switch Settings - Honeywell HNVE1 Reference Manual

1-channel encoder equip series
Table of Contents

Advertisement

PTZ Camera Address Settings

Presets

Document 800-04195 Rev B
11/09
For the PTZ dome and the HNVE1 to be able to communicate, the PTZ switch settings on
the PTZ dome and the HNVE1 encoder must be the same. The PTZ dome switch settings
must agree with the logical address of the PTZ ID. The default setting is 0001.
For example, for the ACUIX High Speed dome, the address selection is via rotary switches
SW1, SW2, SW3, and SW4.
Figure 5-4
Location of Address Rotary Switches on Sample PTZ Main Board
Table 5-2
Sample PTZ Dome Address Switch Settings
Address
SW1
SW2
SW3
SW4
For more about PTZ dome switch settings, please refer to the reference guide provided with
your PTZ dome.
A preset is a saved dome position (pan, tilt, zoom) and lens setting (focus and iris). You can
configure a preset to save a PTZ dome position. Presets enable you to quickly move the
PTZ dome to a particular position while monitoring an area. Presets can be grouped and
sequenced into Preset Tours. When viewing video from a configured preset, the number
and name display in the top left corner of the screen.
There are 161 presets (0 to 160). PTZ dome positions can be saved in all the presets except
preset 71, 72, 73, 75, 98, and 99. These presets are preconfigured for functions such as
resetting cameras and others.
HNVE1 V2.1 1-Channel Encoder Reference Guide
Switches SW1, SW2, SW3, and
SW4, from top to bottom.
Value
Units digit
Tens digit
Hundreds digit
Thousands digit
63

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hnve1 v2.1

Table of Contents