Table 5-5 Example Of Ptz Dome Preset Tour Programming Functions - Honeywell HNVE1 Reference Manual

Encoder and Device Configuration
66
Table 5-5 Example of PTZ Dome Preset Tour Programming Functions
'D' = Delete
'E' = Edit
'S' = Save
7. When complete, program another preset or press
Running a Preset Tour
1. Select the PTZ Dome Setup tab, then click Run.
The Preset Tour OSD appears.
2. Type the number of the desired preset tour, then press
To stop the preset tour, click Halt.
Mimic Tours
For a mimic tour, you record pan, tilt, and zoom commands. Those recorded commands
are played back during the mimic tour. When a mimic tour starts, the dome performs the
saved commands. You can configure 16 mimic tours of up to 120 seconds each.
Configuring a Mimic Tour
1. Select the PTZ Dome Setup tab.
2.
3. Type a number for the mimic tour in the Mimic Tour Details field, then click Program.
The message PROGRAM MIMIC TOUR appears over the video display.
4. Move the PTZ dome using the PTZ Control (see
and zoom commands are saved in the mimic tour. You can continue to save the
commands for 120 seconds.
If you want to stop saving the commands before 120 seconds are over, click Halt.
After you have configured the mimic tour, the message PROGRAM MIMIC TOUR COMPLETE
appears over the video display.
Running a Mimic Tour
1. Select the PTZ Dome Setup tab.
2. Type the required tour in the Mimic Tour Details field, then click Run.
3. Select another option in the PTZ Dome Setup view or click the PTZ control to end the
tour.
Deleting a Mimic Tour
1. Select the PTZ Dome Setup tab.
2. Type the required tour in the Mimic Tour Details field, then click Delete.
The confirmation message Deleted Mimic Tour displays. Press
3.
Deletes the preset tour number entered in
Returns the OSD to edit stage as described in
Saves the preset tour configuration.
Figure 4-5
step 3.
step 5.
Esc
to exit the menu.
Enter
. The tour should begin.
on page 49). The pan, tilt,
Esc
.