Upgrading the Firmware to the Device
Document 800-04195 Rev B
11/09
6.
Type a case-sensitive New Password, and then re-type it in the Verify Password
field.
7.
Click Apply to change the password for the selected user.
To upgrade the firmware to the device:
1.
Navigate to www.honeywellvideo.com.
2.
Click Customer Resources
downloads page.
3.
Locate your device in the list.
4.
Under Honeywell IP Firmware, click the applicable link to download the firmware file
to your computer.
5.
Log onto the Honeywell IP Utility application.
6.
Discover and connect to the device.
7.
On the System tab, click Firmware Upgrade.
Figure 6-1
Firmware Upgrade
Note
It is important to confirm that the selected firmware file is consistent with the
connected device. For example, if you are connected to an HNVE1 encoder,
confirm that the file selected begins with HNVE1_x.x.x.hex.
8.
Follow the upgrade wizard steps to complete the upgrade.
9.
In the Firmware Upgrade dialog box, enter the complete path and name of the *.hex
file in the File Name field, or click Browse to select the file.
10. Click Upgrade. A progress bar shows the progress of the firmware upgrade, followed
by a message confirming that the upgrade is complete.
11. Click OK to reboot the device. The firmware upgrade takes about three minutes and
results in a temporary loss of connection with the device.
HNVE1 V2.1 1-Channel Encoder Reference Guide
➤
➤
Download Center
I Agree to reach the
75