Figure 5-5 Program Preset Tour Osd - Honeywell HNVE1 Reference Manual

Document 800-04195 Rev B
11/09
3. Use the keyboard to enter the required preset number, then press
Preset Tours
For a preset tour, the dome moves from one preset to another. At each preset, the dome
stays for a predetermined time interval (the dwell time) before moving to another preset.
You can configure up to 16 preset tours. In each preset tour, you can specify up to 64
presets.
The length of time that a dome stays at a preset is referred to as the dwell time. The dwell
time can range from 1 to 99 seconds. The speed at which the dome moves from one preset
to another preset is referred to as the velocity. The velocity can range from 1
second.
Configuring a Preset Tour
1. Select the PTZ Dome Setup tab.
2. Under Preset Tour Details, type a number, then click Program.
The Program Preset Tour OSD appears.
Figure 5-5 Program Preset Tour OSD
Using the keyboard, type a number between 1 and 16 for the preset tour, then press
3.
Enter
.
4. Type in a title for the preset tour, then press
5. Enter the values for the Preset, Velocity, and Dwell time for each required preset.
6. When all the presets have been included, press
HNVE1 V2.1 1-Channel Encoder Reference Guide
Enter
.
Enter
to display the following options:
Enter
.
o o
to 480 per
65