Figure 5-10 Board Setup View; Table 5-7 Ptz Configuration Settings - Honeywell HNVE1 Reference Manual

Encoder and Device Configuration
72
Figure 5-10 Board Setup View
1. Select the Board Setup tab.
2. Select from six PTZ dome protocols preconfigured for the dome you have connected
to the encoder. Each PTZ dome has specific baud rate, stop bit, and parity settings.
• Baud Rate settings range from 2400 to 115200.
• Stop Bits settings range from 1 to 2.
• Parity Bits settings range from None, Odd, Even.
Note For the PTZ dome and the HNVE1 to be able to communicate, the PTZ switch
settings on the PTZ dome and the HNVE1 encoder must be the same. See
Configuring a PTZ Dome
switches.
The encoder provides the option of six protocols. The preconfigured values of the baud
rate, stop bit, and parity for each protocol are listed in this table:
Table 5-7 PTZ Configuration Settings
Protocol Baud Rate
Pelco P 4800
Pelco D 2400
Diamond 9600
TM
IntelliBus 38400
VCL 9600
MAXPRO-Net 9600
on page 62 for more information about PTZ
Stop Bit
1
1
1
2
2
2
Parity
None
None
Even
None
None
Even