Monitoring Menu (M1) - Honeywell NX series User Manual

7.3.1

Monitoring menu (M1)

You can enter the Monitoring menu from the Main menu by pushing the
location indication M1 is visible on the first line of the display. How to browse through the monitored values
is presented in Figure 7-4.
The monitored signals carry the indication V#.# and they are listed in Table 7-1. The values are updated
once every 0.3 seconds.
This menu is meant only for signal checking. The values cannot be altered here. For changing values of
parameters see Chapter 7.3.2.
RUN
Monitor
Figure 7-4. Monitoring menu
Code Signal name
V1.1 Output frequency
V1.2 Frequency reference
V1.3 Motor speed
V1.4 Motor current
V1.5 Motor torque
V1.6 Motor power
V1.7 Motor voltage
V1.8 DC-link voltage
V1.9 Unit temperature
V1.10 Motor temperature
V1.11 Voltage input
V1.12 Current input
V1.13 DIN1, DIN2, DIN3
V1.14 DIN4, DIN5, DIN6
V1.15 DO1, RO1, RO2
V1.16 Analogue output current
M1.17 Multimonitoring items
Table 7-1. Monitored signals
* If the unit is supplied with +24V only (for control board power-up) this value is not reliable.
The All in One applications embody more monitoring values.
CONTROL KEYPAD
READY
Local
V1 V14
Unit
Hz
Hz
rpm
A
%
%
V
V
ºC
%
V
mA
mA
Menu button right
RUN
R EADY
Lo ca l
FreqReference
13.95 Hz
RUN READY
Local
Output frequency
13.95 Hz
Description
Frequency to the motor
Calculated motor speed
Measured motor current
Calculated motor shaft torque
Calculated motor shaft power
Calculated motor voltage
Measured DC-link voltage
Heat sink temperature
Calculated motor temperature. See All in One
application manual.
AI1*
AI2*
Digital input statuses
Digital input statuses
Digital and relay output statuses
AO1
Displays three selectable monitoring values. See
chapter 7.3.6.5.
7
77(110)
when the