Acquiring Of Still Pictures And [Mp4] Motion Pictures (Other Than [Avchd] Motion Pictures) - Panasonic Lumix DMC-TS4 Owner's Manual

Acquiring of still pictures and [MP4] motion pictures
(other than [AVCHD] motion pictures)
Preparations:
Turn on the camera and the PC.
Remove the card before using the pictures in the built-in memory.
Connect the computer and camera with the USB connection cable
(supplied).
•
Check the directions of the connectors, and plug them straight in or unplug them
straight out. (Otherwise, the connectors may bend out of shape, causing a
malfunction.) Do not connect devices to incorrect terminals. Doing so may cause
malfunction.
•
Do not use any other USB connection cables except the supplied one.
Use of cables other than the supplied USB connection cable may cause malfunction.
A USB connection cable (supplied)
B Align the marks, and insert.
Press 3/4 to select [PC], and then press [MENU/SET].
•
If [USB Mode]
automatically connected to the PC without displaying the [USB Mode] selection screen.
•
When the camera has been connected to the PC with [USB Mode] set to
[PictBridge(PTP)], a message may appear on the PC's screen. Close the screen by
selecting [Cancel], safely remove the USB connection cable (P167), and set the
[USB Mode] to [PC].
Operate the PC.
•
You can save the images into the PC by dragging and dropping the image or the folder
with the image you would like to transfer onto the different folder in the PC.
Note
•
Use a battery with sufficient battery power or the AC adaptor (optional). If the remaining battery
power becomes low while the camera and the PC are communicating, the alarm beeps.
Refer to " Disconnecting the USB connection cable safely
USB connection cable. Otherwise, data may be destroyed.
•
Before connecting or disconnecting the AC adaptor (optional), turn the camera off.
•
Before inserting or removing a card/battery, turn the camera off and disconnect the USB
connection cable. Otherwise, data may be destroyed.
Connecting to other equipment
(P58) is set to [PC] in the [Setup] menu in advance, the camera will be
- 165 -
" (P167) before disconnecting the