Panasonic Lumix DMC-TS4 Owner's Manual page 60

[Version Disp.]
[Format]
•
Use a battery with sufficient battery power or the AC adaptor (optional) when formatting. Do not
turn the camera off during formatting.
• If a card has been inserted, only the card is formatted. To format the built-in memory, remove
the card.
•
If the card has been formatted on a PC or other equipment, format it on the camera again.
•
It may take longer to format the built-in memory than the card.
•
If you cannot format, contact the dealer or your nearest Service Center.
For USA and Puerto Rico assistance, please call:
1-800-211-PANA(7262) or, contact us via the web at:
http://www.panasonic.com/contactinfo
~ [Language]
•
If you set a different language by mistake, select [~] from the menu icons to set the desired
language.
[Demo Mode]
DEMO
•
The Stabilizer function is switched between [On] and [Off] every time [MENU/SET] is pressed
during the [Stabilizer Demo.].
•
[Stabilizer Demo.] is an approximation.
•
[Auto Demo] is not output to the television.
It is possible to check which version of firmware is on the camera.
The built-in memory or card is formatted. Formatting
irretrievably deletes all the data so check the data carefully
before formatting.
Set the language displayed on the screen.
Displays the amount of jitter the camera has detected. ([Stabilizer
Demo.])
The camera's features are displayed as Slide Shows.
([Auto Demo])
[Stabilizer Demo.]
A Amount of jitter
B Amount of jitter after correction
[Auto Demo]:
[ON]
[OFF]
- 60 -
Basic
For Canadian assistance, please call:
1-800-99-LUMIX (1-800-995-8649) or
send e-mail to: lumixconcierge@ca.panasonic.com
A B