Acquiring of still pictures and [MP4] motion pictures
(other than [AVCHD] motion pictures)
Preparations:
Turn on the camera and the PC.
Remove the card before using the pictures in the built-in memory.
Connect the computer and camera with the USB connection cable
(supplied).
•
Check the directions of the connectors, and plug them straight in or unplug them
straight out. (Otherwise, the connectors may bend out of shape, which will cause a
malfunction.)
•
Do not use any other USB connection cables except the supplied one.
Use of cables other than the supplied USB connection cable may cause malfunction.
A USB connection cable (supplied)
B Align the marks, and insert.
Press 3/4 to select [PC], and then press [MENU/SET].
•
If [USB Mode]
automatically connected to the PC without displaying the [USB Mode] selection screen.
•
When the camera has been connected to the PC with [USB Mode] set to
[PictBridge(PTP)], a message may appear on the PC's screen. Close the screen by
selecting [Cancel], safely remove the USB connection cable (P120), and set the
[USB Mode] to [PC].
Operate the PC.
•
You can save the images into the PC by dragging and dropping the image, or the folder
with the image that you would like to transfer onto a different folder in the PC.
Note
•
Use a battery with sufficient battery power. If the remaining battery power becomes low while
the camera and the PC are communicating, the alarm beeps.
"
Refer to
Disconnecting the USB connection cable safely
USB connection cable. Otherwise, data may be destroyed.
•
Before inserting or removing a card, turn the camera off and disconnect the USB connection
cable. Otherwise, data may be destroyed.
Connecting to other equipment
(P46)
is set to [PC] in the [Setup] menu in advance, the camera will be
- 119 -
"
(P120)
before disconnecting the