Installing The Feed Plate - Brother BAS-326G PS Instruction Manual

10-11-1. Installing the feed plate

1
All indicators switch off
MENU indicator switches off
THREAD/CLAMP indicator illuminates
2
3
Use a 2 mm diameter pin to align the holes in the X feed bracket (3) and the needle plate (4) with the two holes in the
feed plate (5), and then tighten the two bolts (6).
NOTE: Install the feed plate so that the surface with the index mark is facing upward.
4
End feed plate installation mode
While pressing the THREAD/CLAMP key, turn on the power
switch.
* Keep pressing the THREAD/CLAMP key until the model
name is displayed and the buzzer beeps once.
• "CLMP" will appear in the menu display.
Depress the work clamp switch (1) to lower the work clamp, and then
depress the start switch (2).
• After the home position is detected and the work clamp drops, the
feed mechanism will move to the feed plate installation position and
then the work clamp will rise.
Turn off the power.
BAS-326G PS
10. STANDARD ADJUSTMENTS
5005Q
Index
mark
4421Q
4014M
2164B
60