Home Position Detection - Brother BAS-326G PS Instruction Manual

4-7. Home position detection

1876B
4421Q
2154B 2155B
Before starting home position detection, check that the
4950Q
needle bar is at its highest position.
Turn the pulley (1) until the ridge at the bottom of the thread
take-up (2) is aligned with the
Aligned
1. Turn on the power switch.
The power indicator (3) will illuminate, and the model
name [326] will appear in the PROGRAM No. display (4)
and [A-PS] will appear in the menu display (5).
After this, the program number will flash in the
PROGRAM No. display (4).
2. Depress the work clamp switch (6) to lower the work
clamp, and then depress the start switch (7). (After
home position detection is carried out, the work clamp
will move to the sewing start position and then it will
rise.)
*
NOTE:
BAS-326G PS
4. PREPARATION BEFORE SEWING
For programs with a large number of stitches, the
buzzer will sound after the home position is detected,
and then the work clamp will move to the sewing start
position.
If error "E110" is displayed when the start switch (7)
is depressed, turn the pulley (1) in the direction of
operation to clear the error display.
mark on the arm.
24