Home Position Detection - Brother BAS-300G-484/484SF Instruction Manual

4. PREPARATION BEFORE SEWING

4-8. Home position detection

4668M
4421Q
4669M 2155B
25
Before starting home position detection, check that the
4667M
needle bar is at its highest position.
Turn the pulley (1) in the direction of the arrow until the
ridge at the bottom of the thread take-up (2) is aligned with
the mark on the arm.
Aligned
1. Turn on the power switch.
The power indicator (3) will illuminate, and the model
name [bro] will appear in the PROGRAM No. display (4)
and [tHEr] will appear in the menu display (5).
After this, the program number will flash in the
PROGRAM No. display (4).
2. Depress the work clamp switch (6) to lower the work
clamp, and then depress the start switch (7). (After
home position detection is carried out, the work clamp
will move to the sewing start position and then it will
rise.)
* For programs with a large number of stitches, the
buzzer will sound after the home position is detected,
and then the work clamp will move to the sewing start
position.
NOTE:
If error "E110" is displayed when the start switch (7)
is depressed, turn the pulley (1) in the direction of
operation to clear the error display.
BAS-300G-484, BAS-300G-484 SF