7
Close the lower front door, and then close the upper front door.
Resetting the maintenance counter
After installing a new photoconductor, the maintenance counter must be reset. Use one of the following two
procedures:
If a "replace" or "low" message appears
Use these steps when a photoconductor is replaced and 84 Replace <color> photoconductor, 84
<color> photoconductor nearly low, or 84 <color> photoconductor low appears:
1
On the home screen, touch Status/Supplies.
2
Touch Supply Replaced.
3
When Replaced <color> photoconductor appears, touch Yes.
Notes:
•
If more than one photoconductor is replaced, you may need to repeat steps 1 through 3.
•
When Ready appears, the counter is reset.
If a "replace" or "low" message does not appear
Use these steps when a photoconductor is replaced and a "replace" or "low" message does not appear:
1
On the home screen, touch
2
Touch Menus.
3
Touch Supplies Menu.
4
Touch Replace Supplies.
5
Touch the button that indicates the supply item you replaced.
•
All
•
Cyan Photoconductor
•
Magenta Photoconductor
2
1
.
Maintaining the printer
241