Lexmark 734de - X Color Laser User Manual page 270

4
Remove each photoconductor unit, and then place it on a flat surface.
5
Remove the jammed paper, and then replace each photoconductor unit.
6
Close the lower front door.
7
Close the upper front door.
8
Touch Continue.
201 paper jam
1
Open the upper front door, and then open the lower front door.
Warning—Potential Damage: To avoid overexposing the photoconductors, do not leave the front doors open
for more than 10 minutes.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching.
2
Determine where the jam is located, and then remove it:
a
If paper is visible under the fuser, then grasp it on each side and pull it forward.
b
If paper is not visible, then you will need to remove the fuser unit.
Warning—Potential Damage: Do not touch the center of the fuser unit. Doing so may cause your fingers
to touch the roller underneath the fuser unit. Touching the fuser roller will damage the fuser.
2
Troubleshooting
270
1