Removing And Replacing A Drive Cru - TANDBERG STORAGELIBRARY Manual

3 If there is a cartridge in the target tape drive, use the remote management interface or the front
panel interface to eject it.
4 Power off the library.
5 Disconnect the host interface cables from the Drive CRU that you want to remove.
6 From the back of the library, loosen the Drive CRUs thumbscrews.
7 Remove the Drive CRU by gripping the thumbscrews and pulling the entire Drive CRU toward
you.
8 Install a cover plate over the vacant Drive CRU bay. Use a screwdriver to mount the plate.
If you do not have a cover plate, order a replacement. It is important that all vacant slots have a cover
plate to keep unwanted materials out of the library.
Running the library without a cover plate can be dangerous.
Warning

Removing and Replacing a Drive CRU

These instructions explain how to remove a Drive CRU and replace it with a new one.
You can NOT remove a tape drive while the library is powered on. Required tools: None.
1 Prepare host applications for tape drive removal.
2 If there is a cartridge in the Drive, use the remote management interface to eject it.
3 Power off the library.
4 Disconnect the host interface cables from the Drive CRU that you want to remove.
5 From the back of the library, loosen the Drive CRUs thumbscrews.
6 Remove the tape drive by gripping the thumbscrews and pulling the entire tape drive toward you.
7 Add the new tape drive to the vacant slot. Using the guide rails on both the tape drive and the
tape drive bay, slowly slide the tape drive into the bay. The tape drive must be level to slide in
smoothly.
8 Tighten the tape drive's thumbscrews to secure the tape drive to the module. Tighten the
thumbscrews simultaneously; see
The thumbscrews must be aligned with the module's screw holes. If they are not aligned, the tape
drive was not inserted correctly.
9 Connect the host interface cables to the tape drive. If the drive CRU is a SCSI drive, and the drive
is the last device on the bus, you must also connect the SCSI terminator.
10 Power on the library.
11 If necessary, update Drive firmware by following the instructions provided in the
Firmware. The library can use the tape drive immediately after the tape drive firmware is
downloaded.
StorageLibrary T40 Installation and User Guide
Figure 23 Adding, Removing or Replacing a Drive CRU.
Updating
55