Mounting The Storagelibrary T40 In A Rack; Figure 4 Recommended Storage Of Transport Locking Screws - TANDBERG STORAGELIBRARY Manual

Keep the locking screws in a safe place. You will need them to lock the robotics if
Note
you need to return your StorageLibrary T40 for service or repair.
The warranty does not cover damage to the library if transported without the
Caution
locking screws properly installed. See
instructions on how to reinstall the transport lock.

Figure 4 Recommended Storage of Transport Locking Screws

If the library is to be mounted in a rack, this is the time to mount the rackmount ears to the library. See
instructions in section Mounting the StorageLibrary T40 in a

Mounting the StorageLibrary T40 in a Rack

The StorageLibrary T40 is designed for use in a 19" rack system using 4U of rack space. The length
of the power cord and the primary interface cables restrict the placement.
The StorageLibrary T40 is designed to operate in a horizontal position. Do not attempt to operate the
StorageLibrary T40 in any other position than horizontally. Also make sure that:
The airflow around the front and back of the StorageLibrary T40 is not obstructed
There is a minimum of 60cm free space in front of the unit to allow the operator to safely remove
the magazines
The display and operator controls can easily be accessed
The StorageLibrary T40 is away from the floor and in a clean environment with temperatures
within specifications. For specifications and safety information, see
Regulatory Information
The Rack Mounting Kit includes the following items:
Rack Mount Ears (2 ears and 8 screws M3x4)
Left Rail Assembly
Right Rail Assembly
Screw M6x12 (6 pieces)
Recommended mounting tools:
Folding rule or tape measure
Screwdriver
7 mm open-end wrench
12
Reinserting the Transport Lock
Rack.
Specifications
for
and Safety and
Installing the Library