Installing The Tabletop Kit; Installing The Library; Connecting Library Cables (Scsi); Figure 11 Storagelibrary T40 Cabling (Scsi) - TANDBERG STORAGELIBRARY Manual

Installing the Tabletop Kit

The tabletop kit contains the following items:
Tabletop cover
6 M3x6 screws and 6 washers to mount the tabletop cover
4 Tabletop Feet
4 rubber bumpers
8 M3x10 screws
To install the tabletop kit, follow the instructions below. For more details and illustrations refer to
StorageLibrary T40 Table Top Installation
1 Mount the 4 rubber bumpers into the 4 Tabletop Feet.
2 Mount the 4 Tabletop Feet to the library's underside, use M3x 10.
3 Remove 6 screws from the left and right side of the library (3 on each side)
4 Slide the tabletop cover on from top of the unit by bending it out slightly
Fasten the tabletop cover by mounting 6 M3x6 screws and washers on the left and right side of the
library (3 on each side)

Installing the Library

After mounting, you must connect the cables to the library. Two sets of cabling instructions are
available:
For libraries with SCSI tape drives
For libraries with Fibre Channel tape drives
For instructions on cabling a library with SCSI tape drives, see section
(SCSI).
For instructions on cabling a library with Fibre Channel tape drives, see
(Fibre Channel).
If your library includes both SCSI and Fibre Channel tape drives, cable the tape drive following the
appropriate instructions for that tape drive type.

Connecting Library Cables (SCSI)

Use this procedure if you are installing a library that includes SCSI tape drives.

Figure 11 StorageLibrary T40 Cabling (SCSI)

16
Sheet.
Connecting Library Cables
Connecting Library Cables
Installing the Library