Mounting The Storagelibrary T40 To The Rack; Figure 9 Storagelibrary T40 Mounted In A Rack, Front View; Figure 10 Storagelibrary T40 Mounted In A Rack, Rear View - TANDBERG STORAGELIBRARY Manual

Mounting the StorageLibrary T40 to the Rack

Figure 9 StorageLibrary T40 Mounted in a Rack shows the rails mounted in a rack with one screw
M6x12 in upper hole on both left and right side. On the rear side, two screws must be used on both
left and right side. A total of six screws are used to install the rails to the rack.
Make sure that the screws connecting the rails to the rack are tightened properly before installing the
StorageLibrary T40 in the rack.
Slide the StorageLibrary T40 on the rails from the front of the rack.
Fix the StorageLibrary T40 using two M6x12 screws in front of the rack, one on both left and right
side. Referring to the figure below, the lower screw on each side connects the library to the rack,
whereas the upper screw on each side connects the left and right rail assemblies to the rack.

Figure 9 StorageLibrary T40 Mounted in a Rack, Front View.

Figure 10 StorageLibrary T40 Mounted in a Rack, Rear View.

The figure above gives a rear-end view of the StorageLibrary T40 mounted in a rack. The two screws
on each side connect the left and right rail assemblies to the rack.
StorageLibrary T40 Installation and User Guide 15