Punch - Ricoh 9100DN - Aficio SP B/W Laser Printer Software Manual

3. Other Print Operations
• When only 1 page is printed when staples have run out.
• If paper sizes are mixed when a different paper size is specified during a print job.
• When the stapling is cancelled, "Staple Cancelled." appears.
• When printing on letterhead, stapling may not be at the specified position.
• If you cannot make staple settings even with Finisher installed, options may not be set correctly in the
printer driver. Correct option settings in the printer driver. For details, see the printer driver Help.
3
• When duplex printing is selected, adjust staple positions to the binding orientation.
• Depending on the software you are using, print settings may not be saved and the printed result may
not be as expected.
• When setting Staple in the printer driver settings, make sure that a collate option is not selected in the
print settings of the application. If a collate option is selected in the application, printing will not be
as intended.
• When using tracing paper, the vertical/horizontal position of the staples is opposite to the vertical/
horizontal position specified in the printer driver settings.
• Also, staples on the front cover sheet come out reversed.

Punch

With the optional Finisher SR841 or SR4000 installed, holes can be punched into printed output.
Punch Position
The specified punch position varies depending on paper feed and print data orientation. The following
table shows punch positions:
Punch Position
122
AST201S