Wins - Ricoh 9100DN - Aficio SP B/W Laser Printer Software Manual

5. Monitoring and Configuring the Printer

wins

Use the "wins" command to configure WINS server settings.
Viewing settings
msh> wins
• If the IPv4 address obtained from DHCP differs from the WINS IPv4 address, the DHCP address
is the valid address.
Configuration
msh> wins "interface_name" {on | off}
• {on} means "active" and {off} means "inactive".
• Be sure to specify the interface.
• wlan can be specified only when the IEEE 802.11b interface unit is installed.
5
ether
wlan
Address configuration
Use the following command to configure a WINS server IP address:
msh> wins "interface_name" {primary|secondary} "IP address"
• Use the "primary" command to configure a primary WINS server IPv4 address.
• Use the "secondary" command to configure a secondary WINS server IPv4 address.
• Do not use "255.255.255.255" as the IPv4 address.
NBT (NetBIOS over TCP/IP) Scope ID Selection
You can specify the NBT scope ID.
msh> wins "interface_name" scope "scope ID"
• The scope ID can be entered using up to 31 alphanumeric characters.
• Be sure to specify the interface.
• wlan can be specified only when the IEEE 802.11b interface unit is installed.
ether
wlan
222
Interface name
Interface name
Interface configured
Ethernet interface
IEEE 802.11b interface
Interface configured
Ethernet interface
IEEE 802.11b interface