Checking Battery Fluid Level; Charging The Battery; Installing The Battery - MOTO GUZZI GRISO 1100 Manual

u Refit the rider seat, see page 71

(INSTALLING THE BATTERY).

NOTE
For battery installation, see page
71 (INSTALLING THE BATTERY).
CHECKING BATTERY FLUID
LEVEL
Carefully read page 68 (BATTERY).
This vehicle is fitted with a maintenance-
free battery. It is not necessary to check
battery fluid level.

CHARGING THE BATTERY

Carefully read page 68 (BATTERY).
u Remove the battery, see page 70
(REMOVING THE BATTERY).
u Be sure to have a suitable battery charger
at hand.
u Set the battery charger to the required
type of charge (see table).
Connect the battery to the charger.
u
WARNING
Charge or use the battery in a well-
ventilated place. Do not inhale the gas
p r o d u c e d b y t h e b a t t e r y u n d e r
charging.
u Switch the battery charger on.
Electric
Recharge current
(Ampere)
Standard 1.8
WARNING
The battery keeps producing gases for
some time after the battery charger has
been switched off. Allow 5-10 minutes
before refitting the battery.
2
INSTALLING THE BATTERY
Carefully read page 68 (BATTERY).
u Make sure that the ignition switch is in
position "
Time (hours)
u Remove the rider seat, see page 25
(UNLOCKING/LOCKING THE SEAT).
8 – 10
N O T E
positioned in its compartment with the
terminals facing up and towards the
outside of the housing.
u Insert the battery (1) in its compartment.
Upon reassembly, connect first the
positive cable (+) and then the negative
cable (–).
3
1
".
T h e b a t t e r y ( 1 ) m u s t b e
WARNING
use and maintenance Griso 71